UV equipment

UV equipment

UV MACHINERY FLOORMATE + HANDMATE
  • Compact design
  • Manoeuvrable (0˚ turn radius)
  • Instant dimming function for immediate full power
  • Can be used with single-phase power (no three-phase power required)Height-adjustable lamp
  • Ozone-free
  • Equipped with corner detection -UV is turned off automatically when tilted more than 25˚
  • UV lamp will go into dimming mode when not used and will shut off automatically
  • Includes the latest UV-technologies
PREPARATION OF EQUIPMENT
  1. Take a UV curing machine to the site and clean the drive wheels from dirt.
  2. Check that you have all necessary protective equipment – protective overall, safety face mask, safety goggles and gloves.
  3. Before starting work place safety signs in front of the work area and also behind, if necessary.
  4. Place a heat resistant plate under the lamp and adjust the lamp so it remains approximately 5 mm higher from the floor surface.
  5. Connect the UV curing machine to the power outlet.
  6. For adjusting the speed (5-10 m/min.) of the UV curing machine press the buttons “+” and “–“ simultaneously down and then press “enter”.
  7. The UV curing machine is ready when an orange light illuminates on a panel (it will take approximately 45 seconds).
  8. Switch the lamp to the full power from the switch on the left control lever, thereafter adjust the speed with the switch on the right control lever and start working. 
For areas difficult to access use a UV hand lamp.
  1. Take the UV hand lamp out from the case.
  2. Connect the hand lamp to the power outlet and wait approximately 2 minutes until the lamp achieves its full power.
  3. When working with the hand lamp the same safety rules apply as with working with a UV curing machine. 

Regarding the UV curing machinery Synteko cooperates with DECORAD from Netherland. Please contact them for further questions and instructions.

Print